Weider WEBE9997 Instrukcja Użytkownika Pobierz pdf (Strona 9)

10. Insert the two Short Pad Tubes (129) into the Leg

Lever (110). Slide two Foam Pads (128) onto

each Short Pad Tube. Then, press a 19mm

Round Cap (140) into each Foam Pad.

Insert the Long Pad Tube (130) into the Front Leg

(109). Slide two Foam Pads (128) onto the Long

Pad Tube. Then, press a 19mm Round Cap (140)

into each Foam Pad.

9. Grease an M10 x 183mm Bolt (83). Attach the

Backrest Frames (118) and the Seat Frame (122)

o the Bench Frame (107) with the Bolt, two M10

Washers (66), and an M10 Nylon Locknut (65).

o not overtighten the Nylon Locknut; the

Backrest Frames and the Seat Frame must

pivot easily.

See the inset drawing.

Identify the Seat Pin

(123), which is longer than the Curl Pin (not

shown). Attach the Seat Pin to the Seat Frame

(122) with an M4 x 15mm Self-tapping Screw

(95). Then, insert the Seat Pin through the Seat

Frame and the Bench Frame (107).

See step 5. Tighten the M8 Nylon Locknuts (84).

See step 6. Tighten the M6 x 40mm Screws (80).

122

107

Grease

118

128

129

128

110

140

129

123

122

130

109

107

11. Attach the Curl Pad (114) to the Curl Post (113)

with two M6 x 20mm Screws (100).

114

113

100

128

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Komentarze do niniejszej Instrukcji

Brak uwag

Weider WEBE9997 Instrukcja Użytkownika Strona 9

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Nie Weider WEBE9997